zfs@zacklim.com 
Frequently Asked Questions (FAQ)
ZACKTOP
ZackTop is high early strength microconcrete that applied onto rejected or defect floor without hacking it.
No, only in natural concrete colour unless dry-shake hardener is broadcasted on top or apply colour stain.
10-40mm thick.
Car Park, warehouses, logistics, refurbish old building floors. We can even do it for outdoor, best example project is IOI Puchong Mall Roof Top outdoor car park in semi-smooth finish.
Per panel appox. 300-400m2, subject to project site condition & access.
Yes, we sell pre-bag with solution.
ZMO
ZMO is a thin multi-layer micro cementitious overlay that applied onto rejected or undulation floor without hacking it. ZMO cannot mix with colour because it will cause patchy and not uniform of the colour.
It is approx. 3mm – 5mm thick.
It will last at least 10 years, subject to traffic, wear and tear. Yes it’s UV stable.
It will not delaminate if the surface preparation is done properly or unless sharp object fall/scratch on it.
It depends on the substrate. Because ZMO is a thin resurfacing system which lay on top of the substrate. If the substrate is enough to support the weight, ZMO can too.
- Roughen and clean the floor surface
- Mix the material according to the instruction
- Pour the material and screed each layer from coarse aggregate to fine aggregates to fill up the low spot using T-blade
- Mix the material according to the instruction
- Pour the material and screed each layer from coarse aggregate to fine aggregates to fill up the low spot using T-blade
It takes about 1 week for 400m2, because we use 1 layer of coarse aggregates, 1 layer of fine aggregates and 1 layer of finish layer.
HARDEN X
Harden X is a nano-lithium liquid hardener/densifier.
Harden X can harden & densify the floor surface to make it dust-free and better abrasion.
It consists of the latest technology formulation which is lithium based concrete hardener.
About 10m2 / liter. Depends on concrete porousity.
- It can be used for new and existing concrete floor
- Easy to apply
- Dust-free purpose
- Better-abrasion
- Easy to maintain
- React as a transparent shield
- Easy to apply
- Dust-free purpose
- Better-abrasion
- Easy to maintain
- React as a transparent shield
It’s permanent as it is a penetrating system.
Yes.
Yes. About 2-8 mm.
Make sure the floor is clean and free from circumstance, pour and brush it for 30 minutes to let it soak into the concrete. After 30 minutes, clean up with squeegee by removing all the excess material without puddle remain on the surface and let it dry.
By Pump-spray or roller or brush. Do not puddle material.
Yes, no need to buff the floor but in the end of the day, the floor will have a nice sheen.
If it’s wet, any smooth floor surface will be slippery.
It can be used immediately after applying.
It is water-based of lithium silicate.
Yes it is odourless and it does not produce VOCs.
